ESX-8MD MIDI/DINsync Expander

If in doubt, ask.

User Manual

Software

Please proceed to this page to download Silent Way v2 and/or the Max/MSP externals.

ESX-8MD

Please refer to the image below (click to enlarge):

ESX-8MD showing cable orientation

Installation

House the ESX-8MD in a Eurorack case of your choosing. The power connector is Doepfer standard. If using the power cable supplied with the ESX-8MD, the red edge of the cable is nearest the bottom of the PCB, and carries -12V. ("-12V" is marked on the PCB itself next to this end of the connector.) Be sure to connect the other end of the power cable correctly, again so -12V corresponds to the red stripe on the cable.

The ESX-8MD also needs to be connected to an ES-4, ES-40 or ES-5 module. A 10-way cable is supplied with the ESX-8MD. With this cable fitted as shown above, the red strip should be oriented at the other end as shown in the photos in the ES-4 and ES-5 user manuals.